6251聚酰亞胺薄膜F46膠帶

點擊數：866　來源： 揚州鑫州材料有限公司 　日期：2018-07-03

  3.性能要求

注：*為分切前試驗項目

包裝、標志、貯存和運輸

1、膠帶卷、盤應卷在內徑40mm左右的管芯上，然后裝在塑料袋內，封好袋口，再裝入內襯防潮紙的木箱或干燥潔凈的紙箱內。 
2、每一包裝中應附有產品檢驗合格證，箱體上應標明產品名稱；規格批號、毛重、凈重、生產日期、生產廠名稱及“防潮”“防沖擊”等字樣。 
3、該膠帶從生產之日起貯存期為半年，超過貯存期按本標準進行檢驗，合格者仍可使用。
4、膠帶應貯存在避光、干燥、潔凈、通風良好的庫房中。 
5、膠帶運輸時，應避光、防潮、不得重壓、摔打和機械損傷。

6251 Polyimide Film Adhesive Tape F46

Standard No: Q/12YJ4214-2004
Applicable Range: This product is the tape with ground of polyimide film manufactured by "doctor-blading process", single surface or double surfaces covered with glue F46, and processed after drying and cutting. The tape is applicable for acting as grade Hinsulating material of electrical wire lapping. It takes into its shape through melting at 350-380℃ over ten minutes.

1.Technological requirement:
1.1 Appearance: The tape is dry, smooth as well as free from any bubble or impurity, etc.
1.2 Dimension:
1)Length: The length of every roll of tape is not less than 300m and the number of sections is no more than 4.
2)Width and allowable deviation of tape is 10mm±0.5mm，15mm±0.5mm，20mm±1mm，and 25mm±1mm. Tape with other width specifications can be offered according to the requirements of customer.
3)Nominal thickness and allowable deviation: thickness range 0.03mm -- 0.10mm, allowable deviation is ±0.005mm -- ±0.006mm, or supply will be done according to the requirements of customer.
1.3 Performances of tape shall conform to the stipulations in Table One.